Material Safety Data Sheet
1. Chemical Product and Company Identification
DESCRIPTION: ELMER'S CRAFT BOND RUBBER CEMENT
PRODUCT TYPE: NATURAL RUBBER
APPLICATION: E425, E64425
· Manufacturer/Supplier Information
MSDS Prepared by:
Elmer's Products, Inc. Emergency Phone Number
1 Easton Oval Poison Control Center
Columbus, OH 43219 1-888-516-2502
For additional health, safety or regulatory information, call 1-888-435-6377.
Call 1-800-848-9400 to place an order or request additional MSDSs.
2. Composition, Information on Ingredients
The ingredients listed below have been associated with one or more
immediate and/or delayed(*) health hazards. Risk of damage and effects
depends upon duration and level of exposure. BEFORE USING, HANDLING, OR
EXPOSURE TO THESE INGREDIENTS, READ AND UNDERSTAND THE MSDS.
% by weight
67-63-0 *Isopropanol 1-5
142-82-5 Heptane >70
3. Hazards Identification
3.1 Emergency Overview
Appearance Opaque liquid
Odor Mild solvent
DANGER!
EXTREMELY FLAMMABLE LIQUID AND VAPOR
May be harmful if inhaled. May cause irritation of nose, throat and
lungs.
Can cause central nervous system depression.
Causes eye irritation.
· HMIS Rating
HEALTH = 2 (moderate)
FLAMMABILITY = 4 (severe)
REACTIVITY = 0 (minimal)
CHRONIC = *
3.2 Potential Health Effects
· Immediate Hazards
INGESTION: Not expected to be harmful under normal conditions of
use.
If accidentally swallowed, burns or irritation to
mucous membranes, esophagus or GI tract can result.
INHALATION: May be harmful if inhaled. Liquid or vapor may cause
irritation of nose, throat and lungs.
Can cause central nervous system depression.
SKIN: May cause irritation on prolonged or repeated contact.
EYES: Causes irritation.
Isopropanol 67-63-0
Can cause central nervous system depression. Signs and symptoms may
include headache, dizziness, nausea, vomiting, unconsciousness and
even asphyxiation.
Heptane 142-82-5
Can cause central nervous system depression. Signs and symptoms may
include headache, dizziness, nausea, vomiting, unconsciousness and
even asphyxiation.
· Delayed Hazards
Isopropanol 67-63-0
Suspect reproductive hazard. May cause reproductive disorders
based on animal data.
May cause liver damage based on animal data.
May cause kidney damage based on animal data.
-- See Footnote C.
Footnote C: As of the date of issuance of this document, this
material has not been listed by NTP, classified by IARC nor regulated
by OSHA as a carcinogen.
4. First Aid Measures
INGESTION: If accidentally swallowed, dilute by drinking large
quantities of water. Immediately contact poison control
center or hospital emergency room for any other
additional treatment directions.
INHALATION: If inhaled, remove to fresh air. If not breathing,
give artificial respiration, preferably mouth-to-mouth.
Call a physician.
SKIN: In case of irritation, flush with water.
EYES: Immediately flush eyes with plenty of water for at
least 15 minutes. Eyelids should be held apart during
irrigation to insure water contact with entire surface of
eyes and lids. Call a physician.
5. Fire Fighting Measures
Autoignition Temperature Not available
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available/1
Flash Point -10 deg C (TCC)
EXTREMELY FLAMMABLE LIQUID AND VAPOR.
Keep liquid and vapor away from heat, sparks, flame and other ignition
sources including, but not limited to, pilot lights, heaters,
cigarettes, electric motors and static discharge. Vapor is heavier
than air and may settle in low places or travel outward to a source of
ignition and flashback.
In case of fire, use water spray, dry chemical, foam or CO2. Use
water to keep fire-exposed containers cool.
6. Accidental Release Measures
Eliminate all ignition sources. Soak up with absorbent material and
remove to a chemical disposal area. Prevent entry into natural bodies
of water.
7. Handling and Storage
7.1 Handling
Handle in accordance with good industrial hygiene and safety
practices. These practices include avoiding unnecessary exposure and
removal of the material from eyes, skin and clothing.
Wash thoroughly after handling. Always use appropriate Personal
Protective Equipment (PPE).
INHALATION: Avoid breathing vapor. Use with adequate
ventilation.
SKIN: Avoid prolonged or repeated contact with skin and clothing.
EYES: Avoid contact with eyes.
7.2 Storage
Store in a cool, dry place.
Keep containers tightly closed.
Keep away from heat, sparks, flame and other ignition sources.
Use with adequate ventilation.
8. Exposure Controls/Personal Protection
8.1 Exposure Controls
ENGINEERING CONTROLS: The following exposure control techniques may
be used to effectively minimize employee exposure: local exhaust
ventilation, enclosed system design, process isolation and remote
control in combination with appropriate use of personal protective
equipment and prudent work practices. These techniques may not
necessarily address all issues pertaining to your operations. We,
therefore, recommend that you consult with experts of your choice to
determine whether or not your programs are adequate.
If airborne contaminants are generated when the material is heated or
handled, sufficient ventilation in volume and air flow patterns should
be provided to keep air contaminant concentration levels below
acceptable criteria.
8.2 Personal Protection
Where air contaminants can exceed acceptable criteria, use NIOSH/MSHA
approved respiratory protection equipment. Respirators should be
selected based on the form and concentration of contaminants in air
in accordance with OSHA laws and regulations or other applicable
standards or guidelines, including ANSI standards regarding
respiratory protection. Use goggles if contact is likely. Wear
impervious gloves as required to prevent skin contact.
8.3 Exposure Guidelines
Isopropanol 67-63-0
ACGIH TLV: 400 ppm (983 mg/m³) TWA; 500 ppm (1230 mg/m³) STEL
OSHA PEL: 400 ppm (980 mg/m³) TWA
REMANDED PEL: 400 ppm (980 mg/m³) TWA; 500 ppm (1225 mg/m³) STEL
OSHA 1989 PEL remanded, but in effect in some states
Heptane 142-82-5
ACGIH TLV: 400 ppm (1640 mg/m³) TWA; 500 ppm (2050 mg/m³)STEL
OSHA PEL: 500 ppm (2000 mg/m³) TWA
REMANDED PEL: 400 ppm (1600 mg/m³) TWA; 500 ppm (2000 mg/m³)STEL
OSHA 1989 PEL remanded, but in effect in some states
9. Physical and Chemical Properties
Percent Volatiles 90
pH @ 25 C Not applicable
Specific Gravity 0.71
Appearance Opaque liquid
Autoignition Temperature Not available
Boiling Point 90 deg C
Vapor Density (Air=1) > 1
Vapor Pressure, mm Hg @ 20 C Not available
Evaporation Rate (Butyl Acetate=1) < 1---(ether=1)
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available/1
Flash Point -10 deg C (TCC)
Freezing Point Not available
Odor Mild solvent
Odor Threshold, ppm Not available
Solubility in Water Negligible
Coefficient of Water/Oil Distrib. Not available
10. Stability and Reactivity
Normally stable as defined in NFPA 704-12(4-3.1).
· Conditions to Avoid:
Exposure to heat, flame and incompatibles.
· Incompatibilities:
Acids, bases, amines.
· Decomposition products may include:
CO, CO2.
· Hazardous polymerization:
Will not occur.
· Other Hazards:
None known to company.
11. Toxicological Information
See Section 3 Hazards Identification information.
Isopropanol 67-63-0
LC50: rat=16000 ppm/8H (Sax)
LD50: orl-rat=5.8 g/kg (Merck); skn-rbt=13 g/kg (Sax)
Heptane 142-82-5
LC50: Not available
LD50: Not available
12. Ecological Information
Not determined.
13. Disposal Considerations
Recover free liquid. Absorb residue and dispose of according to
local, state/provincial, and federal requirements.
Empty container: May contain explosive vapors. DO NOT cut, puncture
or weld on or nearby.
14. Transport Information
14.1 U.S. Department of Transportation (DOT)
The data provided in this section is for information only and may not
be specific to your package size. You will need to apply the
appropriate regulations to properly classify your shipment for
transportation.
ORM-D Consumer Commodity.
14.2 Canadian Transportation of Dangerous Goods (TDG)
Not determined.
15. Regulatory Information (Selected Regulations)
15.1 U.S. Federal Regulations
· OSHA Hazard Communication Standard 29CFR1910.1200
This material is a "health hazard" and/or a "physical hazard" as
determined when reviewed according to the requirements of the
Occupational Safety and Health Administration 29 CFR Part 1910.1200
"Hazard Communication" Standard.
· SARA Title III: Section 311/312
Fire hazard
Immediate health hazard
Delayed health hazard
· SARA Title III Section 313 and 40 CFR Part 372
This product contains the following toxic chemical(s) subject to the
reporting requirements of Section 313 of Title III of the Superfund
Amendments and Reauthorization Act of 1986, and Subpart C-Supplier
Notification Requirement of 40 CFR Part 372.
None required per SARA TITLE III SECTION 313.
· TSCA Section 8(b) Inventory
All reportable chemical substances are listed on the TSCA Inventory.
We rely on certifications of compliance from our suppliers for
chemical substances not manufactured by us.
15.2 Canadian Regulations
· Workplace Hazardous Materials Information System (WHMIS)
This product has been classified in accordance with the hazard
criteria of the Controlled Products Regulation (CPR) and the MSDS
contains all the information required by the CPR.
CLASS D, DIV 2B
CLASS B, DIV 2
· Canadian Environmental Protection Act (CEPA)
All reportable chemical substances are listed on the Domestic
Substances List (DSL) or otherwise comply with CEPA new substance
notification requirements.
· National Pollutant Release Inventory (NPRI)
This product contains the following chemical(s) subject to the
reporting requirements of the Canadian Environmental Protection Act
(CEPA) subsection 16(1), National Pollutant Release Inventory.
Isopropyl alcohol 67-63-0 1.49%
16. Other Information
CL (Cautions Required): Products bearing the CL Health Label
(Cautions Required) Seal of The Art & Creative Materials Institute,
Inc. (ACMI) are certified to be properly labeled in a program of
toxicological evaluation by a medical expert. This program is
reviewed by ACMI's Toxicological Advisory Board. These products are
certified by ACMI to be labeled in accordance with the chronic hazard
labeling standard, ASTM D-4236 and Federal Law, P.L. 100-695.
· User's Responsibility
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace
Hazardous Materials Information System (WHMIS) require that the information
contained on these sheets be made available to your workers. Educate and
train your workers regarding OSHA and WHMIS precautions. Instruct your
workers to handle this product properly. Consult with appropriate experts
to guard against hazards associated with use of this product and its
ingredients.
· Disclaimer
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE
MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product
shall conform to contracted specifications, and that the product does not
infringe any valid United States or Canadian patent. No claim of any kind
shall be greater in amount than the purchase price of the quantity of
product in respect of which damages are claimed. In no event shall Seller
be liable for incidental or consequential damages, whether Buyer's claim is
based on contract, breach of warranty, negligence or otherwise.
CURRENT ISSUE: 18-SEP-10
PREVIOUS ISSUE: 14-JAN-10