XEROX CORP -- 1025/1038 RED DRY INK PLUS, 6R123 -- 6850-00N051706 
=====================  Product Identification  =====================

Product ID:1025/1038 RED DRY INK PLUS, 6R123
MSDS Date:03/15/1990
FSC:6850
NIIN:00N051706
=== Responsible Party ===
Company Name:XEROX CORP
Address:100 S CLINTON AVE
City:ROCHESTER
State:NY
ZIP:14644
Country:US
Info Phone Num:800-828-6571
Emergency Phone Num:716-422-2177
CAGE:0E6G9
=== Contractor Identification ===
Company Name:XEROX CORP
Address:300 MAIN ST NO 27C
City:EAST ROCHESTER
State:NY
ZIP:14645
Country:US
Phone:800-828-6571; 800-351-2024
CAGE:0E6G9
Company Name:XEROX CORPORATION
Address:100 CLINTON AVE SOUTH
Box:City:ROCHESTER
State:NY
ZIP:14644-1877
Country:US
Phone:800-828-6571/716-422-2177
CAGE:26921

=============  Composition/Information on Ingredients  =============

Ingred Name:STYRENE, ACRYLATE COPOLYMER; (STYRENE/ACRYLATE POLYMER)
CAS:25213-39-2
Fraction by Wt: 60-65%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:ACRYLIC RESIN
CAS:26299-47-8
Fraction by Wt: 25-30%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:FIRE RED 2B; (RED PIGMENT (BARIUM SALT))
CAS:7585-41-3
Fraction by Wt: 10%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:PROPENE POLYMERS; (POLYOLEFIN)
CAS:9003-07-4
RTECS #:UD1842000
Fraction by Wt: <5%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:MAGENTA PIGMENT; QUINOACRIDINE DERIVATIVE
CAS:980-26-7
Fraction by Wt: <1%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:SILICON DIOXIDE, AMORPHOUS; (AMORPHOUS SILICA)
CAS:7631-86-9
Fraction by Wt: <1%
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:LD50:(ORAL,RAT) >5 G/KG.
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:MINIMAL RESP TRACT IRRIT MAY OCCUR AS
    W/EXPOS TO LG AMTS OF ANY NON-TOX DUST. IN A XEROX SPONSORED
    CHRONIC INHAL STUDY IN RATS USING A SPECIAL TEST TONER, A VERY
    SLIGHT DEGREE OF FIBROSIS WAS NOTED IN  25% OF ANIMALS AT MIDDLE
    EXPOS LEVEL (4 MG/M3) WHILE A SLIGHT DEGREE OF FIBROSIS WAS
    OBSERVED AT (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:HIGHEST EXPOS LEVEL (16 MG/M3) IN ALL
    ANIMALS. THESE FINDINGS ARE ATTRIBUTED TO "LUNG OVERLOADING",
    GENERIC RESPONSE TO EXCESSIVE AMTS OF ANY DUST RETAINED IN LUNGS
    FOR PRLNG INTERVAL. SPECIA L TEST TONER WAS 10 TIMES MORE
    RESPIRABLE THAN COMMERCIALLY AVAIL XEROX TONER TO COMPLY W/EPA
    TESTING PROTOCOL &(SUPDAT)
Medical Cond Aggravated by Exposure:NONE WHEN USED AS DESCRIBED BY
    PRODUCT LITERATURE.

=======================  First Aid Measures  =======================

First Aid:EYES:FLUSH W/WATER FOR AT LEAST 15 MINUTES. SKIN:WASH W/SOAP
    & WATER. INHAL:REMOVE FROM EXPOSURE. INGEST:DILUTE STOMACH CONTENTS
    W/SEVERAL GLASSES OF WATER.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:WATER, DRY CHEMICAL, CARBON DIOXIDE OR FOAM.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . AVOID INHALATION OF SMOKE.
Unusual Fire/Explosion Hazard:TONER IS A COMBUSTIBLE POWDER. LIKE MOST
    ORGANIC MATERIALS IN POWDER FORM, WHEN DISPERSED IN AIR, IT CAN
    FORM EXPLOSIVE MIXTURES.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SWEEP UP/VACUUM SPILLED TONER & CAREFULLY
    TRANSFER INTO SEALABLE WASTE CNTNR. SWEEP SLOWLY TO MIN GENERATION
    OF DUST DURING CLEAN-UP. IF VACUUM IS USED, MOTOR MUST BE RATED AS
    DUST TIGHT. CONDUCTIVE H OSE BONDED TO MACHINE SHOULD BE USED
    TO(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:NONE
Other Precautions:AVOID PROLONGED INHALATION OF EXCESSIVE DUST.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NONE REQUIRED WHEN USED AS INTENDED IN XEROX
    EQUIPMENT. FOR USE OTHER THAN NORMAL CUSTOMER-OPERATING PROCEDURES
    (SUCH AS BULK TONER PROCESSING FACILITIES), NIOSH/MSHA APPROVED
    RESPIRATORS MAY BE REQUI RED. FOR MORE INFO, CONTACT XEROX.
Ventilation:NONE SPECIFIED BY MANUFACTURER.
Protective Gloves:NONE REQUIRED WHEN USED AS INTENDED.
Eye Protection:NONE REQUIRED WHEN USED AS INTENDED.
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EFTS OF OVEREXP:WOULD NOT FUNCTION PROPERLY IN XEROX EQUIPMENT. FURTHER
    INFORMATION ON FILE IN POISINDEX. SPILL PROC:REDUCE STATIC BUILDUP.
    RESIDUE CAN BE REMOVED W/SOAP & COLD WATER. GARMENTS MAY BE  WASHED
    OR DRY CLEANED, AFTER REMOVAL OFLOOSE TONER.

==================  Physical/Chemical Properties  ==================

Spec Gravity:1 (H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:RED POWDER; FAINT ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:PRODUCTS OF COMBUSTION ARE TOXIC.
    AVOID BREATHING SMOKE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF I/A/W FEDERAL, STATE & LOCAL
    REGULATIONS. INCINERATE ONLY IN A CLOSED CONTAINER.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.